Mar-K Condition Parts makes replacement parts for most classic American trucks.
Mar-K Affection Parts in Oklahoma Conurbation specializes in the manufacturing of classic Motor lorry parts for Chevy, GMC, Ford, Dodge and heterogeneous other custom trucks. The installation of Motor lorry Bedstead kits is idiosyncratic to Everyone cause and mannequin of Motor lorry. Particular dossier is generally required regarding the attachment of the Bedstead to the Motor lorry frame. This material is available in install guides for most makes and models from Mar-K. The regular procedure is the duplicate for most Motor lorry beds.
Instructions
1. Attach one corner of the front Bedstead panel to one side panel using the front Bedstead panel mounting apparatus hardware. Repeat the development with the antithesis side panel to construction the box of the Bedstead.
2. Install the rear cross sill, becoming it into the openings at the backside of the stake pockets in the back corners of the Bedstead. Leave bolts loose for adjustment.4. Install the remaining wood boards and bed strips, fitting them into the slot in the rear sill.
Location the bolt holes in the angle onto the boards and Muzzle 3/8-inch holes in Everyone direction. Bolt the edge boards to the angle with the provided bolts. Bolt the ends of the rear sill to the angle too. Bolt it in city with indented hex mind bolts and washers.3. Field the path boards under the Bedstead side angle trim.
Fit the bed strip edges into the grooves cut along the long edge of each board, one bed strip in the seam between each two boards. Thread the bolts into the rear sill, keeping the nuts loose for adjustment.
5. Lift the bed assembly onto the truck. Locate and align the holes for the bed to frame bolts. Add wood or rubber spacers as required for your specific model and bolt the bed to the frame using the provide bed to frame bolts, washers and nuts.
6. Tighten all bolts once the bed to frame bolts are aligned with an impact gun. Attach the tail gate by sliding in the hinge pins at the bottom and aligning the latches at the top.
7. Bolt the fenders to the bed side and frame. If your new fenders do not have bolt holes, consult the original fenders for bolt placement and drill a 3/8-inch hole in each location to match the original.
