Removing the electric starter from your Polaris snowmobile is not that laborious.
The positive cable is still attached to the back side of the unit. Pull the protective cap away from the bolt and remove it. Disconnect the battery lead and remove the starter from the sled.8.
Instructions
1. Airy the hood of the snowmobile by releasing the two rubber connectors on Everyone side of the hood surround.
2. Disconnect the balky cause from the battery. Treasure trove the electric starter, which is located on the left side of the engine consequent to the battery.
3. Using pliers, carefully remove the two springs that hold the exhaust main to the exhaust manifold. Remove the retaining spring on the Way out site of the channel that holds the conduit to the snowmobile frame. Remove the exhaust main away and out from the snowmobile.
4. On some models, you must remove the exhaust manifold to dividend access to the starter. Using an open-end wrench, remove the six nuts that clutch the exhaust manifold to the engine block and remove it from the sled.
5. Establish the two starter mounting brackets. There is one on Everyone site of the starter. Using an open-end wrench, remove the bolt that connects the starter to the mounting bracket at the gear edge of the unit. There Testament be a ebony opposite cable connected to it that goes to the battery. This bracket will remain connected to the block.
6. Using an open-end wrench, remove the two bolts that hold the mounting bracket to the engine at the opposite end.
7. Carefully pull the starter out and away.The dilatory summer and fall months are a fine age to evaluation and repair your snowmobile in preparation for the upcoming season. Some snowmobiles are equipped with electric starters that eliminate the require for pulling the starter rope day after future to receive the engine started. After duration, these starters wear away and entail replacement. Advantage these effortless steps to remove the starter from your Polaris Indy snowmobile.
Using an open-end wrench or socket, remove the two bolts holding the remaining bracket to the starter
9. Install the new starter by reversing this process.
