American Make-believe Sportscar
7. Vertically lift the fuel sender and fuel pump meeting gone of the vehicle.8.
Instructions
Fuel Pump Removal
1. Remove the denying cable from the battery using a battery terminal wrench. Remove the Gauze cap from the fuel filler valuable into the Gauze vat.
2. Remove the fuel filler door by loosening the four Torx screws with a Torx bit and ratchet.
3. Peel up the rubber mat sorrounding the fuel vehicle filler tube. Remove the mat to expose the screws holding the fuel sender cover plate.
4. Remove the eight screws in the fuel sender cover plate with a brief metric socket and ratchet.
5. Loosen the clamps for the fuel reinstate wrinkle, fuel nourishment border and vapour hose with a flat-bladed screwdriver. Pull Everyone hose gently to disconnect it from the fuel sender encompass plate.
6. Disconnect the electrical connexion to the fuel sender by gently prying the connector's locking mechanism with your labourer. Pull the connector unrestrained from the sending encompass by gently wiggling it with a sidewise movement.
The fuel pump in a 1987 Chevrolet Corvette is a solution Element to engine performance. Fuel is supplied to the engine complete an electric fuel-injection step. Insufficient fuel impulse in the fuel-injection method for the 350-cubic-inch, V-8 engine Testament by-product in stalling, stumbling or failure to fall. A fuel pump failure Testament corollary in an engine that Testament not escape at all. Fuel pump issues occur from internal components stressful elsewhere or damage from debris in the petrol.
Remove both electrical connectors on the fuel pump. Loosen the fan on the fuel aliment borderline with a unbarred extremity metric wrench to remove the fuel pump.
Fuel Pump Replacement
9. Connect the new fuel pump to the fuel feed line by tightening the nut onto the fuel pump. Reattach both electrical connectors to the fuel pump.
10. Insert the fuel pump assembly into the gas tank and align the screw holes in the fuel sender cover with the openings in the fuel tank. Insert the eight screws into the fuel sender cover and tighten using a metric socket and ratchet.
11. Return the fuel feed line, fuel return line and fuel vapor hose to the original position and secure with the clamps. Tighten the clamps using a flat blade screwdriver. Slide the electrical connector over the receptacle on the fuel sender cover until it locks in place.
12. Return the rubber mat to its original position over the fuel sender cover.
13. Reinstall the fuel filler door and secure with the four Torx screws. Tighten the gas cap on the fuel filler tube.
14. Reattach the negative battery cable to the battery with the battery terminal wrench.
