Replacing rear windows is not still deviating than replacing front ones. It and might not happen as much in that most damage recurrently occurs to the front windows. Deeper than anything, cook persuaded that any replacement window glass is not conscientious for your constitute and replica vehicle on the contrary as well designed for the rear door and not the front. The two larger causes for window replacement distortion in the glass itself and the regulator holding it within the door.
Instructions
Remove the bolts for the window regulator and remove it from the window by folding it up and pulling it out through the main hole in the side of the door. This is only needed if you are replacing the regulator.9.
2. Remove all switches and handles in the door. For switches, pry off their trim bezels with a trim stick and disconnect their electrical connectors. For a window crank, insert a hooked tool behind the handle to disengage its clip. If you can't get such a tool, try rubbing a cloth in between the handle and door panel.
3. Detach the door trim panel by removing its screws and lifting the door off of its clips. On a lot of cars, the screws are behind trim panels like the door handle and pull handle; pry these panels off with the trim stick. You might also need to pry the panel off its fasteners by inserting the trim stick behind it.
4. Peel back the plastic watershield that is stuck onto the door, taking care not to damage it.
5. Pull the weatherstripping off the top of the door.
Replace the Window
6. Disconnect the bolts attaching the window glass to its regulator using a wrench. You may be able to use a standard wrench on some bolts, but other models may require something special like a Torx wrench.
7. Lift the glass up and out the door through the slot in the top. If the window is cracked or broken, be especially careful removing it; wearing gloves and long sleeves can help. Set the glass aside if it is not damaged and you're only replacing the regulator.
8.
Access the Window
1. Roll the window glass all the action down and then disconnect the denying battery cable. This might not be as needed as with a front door, particularly provided the automobile has guidebook windows, however it's yet a capital precaution in plight there are any electrical connectors endure the door panel.Install the new regulator in place within the door and secure it with the bolts.
10. Lower the glass--either the old glass if it's still in good shape or new glass--through the upper door slot, position it within the regulator and bolt it in place within the regulator.
11. Replace the door panel and all components, switches, handles and cables in the reverse order that they were removed.
