If equipped with the 3.6-liter, six-cylinder engine or with the 4.6-liter, eight-cylinder engine, the 1998 Mustang was equipped with a unmarried starter Engine. The Individual speck of the starter is to turn the engine blue streak Sufficiently for the engine's ignition step to begin the engine. A bad starter Engine is indicative of a worn starter clutch. Although it may be impractical to rebuild the starter, replacing the starter with a late unit is quite straightforward, and the formation is the duplicate regardless of the type of engine.
Instructions
1. Stand the front of the Mustang with a jack. Position the vehicle on jack stands placed underneath the frame.
9. Peel the tape pieces off the wires. Lower the car to the ground.
Tag the wiring with masking tape to avoid incorrectly installing the wires upon reassembly.
4. Disconnect the wiring at the starter by using a deep-set socket wrench to remove the nuts that secure the wires against the starter motor.
5. Unfasten the starter's two mounting bolts with a socket wrench. Lower the starter out of the transmission's bellhousing.
6. Position the new starter motor against the transmission's bellhousing, ensuring the mounting bolts on the starter align with the holes on the bellhousing.
7. Install and tighten the starter's two mounting bolts with a socket wrench.
8. Position the starter's wires onto their threaded rods. Install and tighten the nuts with a socket wrench.
2. Fix the starter motor on the passenger's side of the engine, where the engine attaches to the transmission.3.
