Friday, July 31, 2015

Switch The Brake Pads On The 2004 Honda

Replacing a establish of brake pads on your 2004 Honda is not insoluble to end. Doing the project yourself Testament save you a group of almighty dollar in labour costs at the repair shop. Brake pads wear thanks to they call friction to slow and brick wall your Honda. The brake pads squeeze the rotor between them when you depress the brake pedal.4. Insert the new brake pad retaining clips into the caliper. Place the brake pads into the caliper then place the shims behind the brake pads.



Disclosed the engine compartment and remove most of the brake fluid from the brake skilled cylinder with a turkey baster. The master cylinder is on the back wall of the engine compartment on the Chauffeur's side of the motorcar. Assign the fluid into the filter pan for succeeding recycling.


2. Area shove chocks ultimate the rear wheels. Up thrust the Honda with an vehivle jack. Dwelling jack stands under the vehivle near the jacking points and uplift them to the frame. Loosen the lug nuts on one of the wheels with a lug wrench then takings the rotate off the automobile.


3. Remove the bolt holding the brake hose to the bracket with a wrench. Remove the locking bolt from the brake caliper with a socket and ratchet. Axis the caliper up and off the wheel assembly. Pull the brake pads and shims out of the brake caliper. Pull the old caliper retaining clips off the caliper.


You should copper the brake pads when they span the recommended minimum thickness, or the repair Testament pass into bounteous expensive as the rivets from the brake pads start to chop grooves into the rotors.

Instructions

1. Pivot the caliper down onto the wheel assembly. Tighten the retaining bolt with the socket and ratchet.


5. Remount the wheel onto the Honda and tighten the lug nuts with the lug wrench. Repeat this process on the other wheel then remove the jack stands from under the Honda and lower it to the ground. Add brake fluid to the master cylinder if necessary. Pump the brake pedal several times until the pedal is firm to seat the brake pads onto the rotors.