Transform the Starter on a 1992 Honda Accord
Replacing the starter Engine in your 1992 Honda Correspond is a positive project for the family mechanic and Testament yield you approximately an day with basic participation tools. The starter is located on the front of the engine near the radiator and up against the call housing of the transmission. Once it is outside of the motorcar, the starter can be bench-tested to complete provided it is malicious at most auto-parts stores or the Honda dealership.
Instructions
1. Establish the balky battery cable on the absent battery terminal, then remove the retaining bolt with a wrench. Allot the cable aside so it cannot contact the terminals on the battery while you are working.
2. Hoist the front of the van with a jack and block it on a establish of jack stands positioned under the frame rails of the automobile. Slide under the front of the vehivle and fix the starter on the front of the engine.
3. Establish the wiring harness connections on the rear of the starter solenoid. Depress the locking tab on the electrical connector and pull it outside of the solenoid. Remove the retaining devotee on the moment terminal with a socket and ratchet, then remove the cable from the starter.
4. Remove the two mounting bolts on the nose of the starter with a socket and ratchet. Slide the starter back and lower it gone of the van. Position the different starter into the engine compartment and slide the starter into the telephone housing. Install the two mounting bolts and tighten them with a socket and ratchet.
7. Connect the negative battery cable to the negative post of the battery and install the retaining bolt. Tighten the bolt with a wrench and close the hood. Slide the second connector onto the post terminal followed by the retaining nut, then tighten it with a socket and ratchet.
6. Raise the front of the car off the jack stands with a jack. Remove the jack stands from under the car and lower it to the ground.
5. Connect the electrical connector from the getting on starter to the connector on the rear of the latest starter. Push it in until it snaps in compass.
