DIY: You don't always charge to receive a pro to change a vehicle's damaged passenger side window.
When the passenger window in a vehicle is cracked or has been damaged it Testament occasion to be replaced with a cutting edge window. A just out passenger window can be installed by a licensed or you can save income for the repair and effect the employment yourself. You can exchange a passenger side window by head obtaining a inexperienced or replacement window from an Car advantage store or your community junk yard.
Seperate the glass channel from the regulator arm and then lift the glass gone of the window. Set the old window aside.10.
2. Acquisition and remove the screws that are used to secure the ability window and door lock state panel with the screwdriver. Lift the dominion panel up and disconnect the electrical connector harness. Place the check panel aside.
3. Good buy and remove the screws that are located under the trim panel at the backside of the door.
4. Pull slowly from the top of the inside door panel until it begins to seperate from the door. Measure down Everyone side of the door panel to seperate it from the door. Accept the inside door panel off and fix it aside.
5. Pull the plastic clips outside of the door with a duo of pliers and locate them aside. Lift up the plastic movie that is covering the inside of the door.
6. Pull up on the weatherstripping to remove it from the door.
7. Boast and remove the glass lift plate bolts with the socket wrench. Turn the socket wrench to the left or counterclockwise to loosen and remove the bolts.
8. Treasure trove and remove the bolts that are used to secure the front glass flight channel and then pull the channel forward slightly.
9.
Instructions
1. Roll down the passenger-side window to be replaced.Insert a new window into the door. Position the back of the window into the rear glass run channel. Secure the glass channel to the regulator arm by tightening the nuts onto the bolts.
11. Position the front of the window into the front run channel. Secure the glass channel with the bolts.
12. Place the weatherstripping back onto the top of the door and then test the window to make sure it is working properly.
