A Expert looking protest Testament cook your RC van stand absent.
It does not event how swiftly your RC automobile is or how all the more bankroll you spend on it; a poorly trumped-up protest Testament build your vehivle scrutinize cheap and unattractive. Production your own RC automobile intent is not laborious however it does desire a plenty of bit and patience. Once you bargain a lexan RC van body that you demand to appropriateness on your automobile, proceed from the steps outlined here to discover a target that Testament make your RC automobile stand absent from remainder of the pack.
Instructions
1. Sand the inside of the Lexan body with 1000-grit sandpaper. This will give the paint a rough surface to adhere to which will help against cracking and peeling. Do not worry, the scratches will not show once the car has been painted.
2. Wash the inside of the body with Dawn blue dish soap or a similar dish soap.4. Spray light layers of paint onto the inside of your prepped RC car body. Light layers ensure the paint does not bleed, facilitates faster drying times and coats more evenly. Take your time here and allow the paint to fully dry between coats. If you are doing a two-tone finish, such as painting racing stripes a different color than remainder of the body, complete your first color's coats first. Once that is dry, carefully peel away the masking or tape that kept paint off of your design. Spray over that with the second color with light coats until it is painted to your liking.5. Trim the body with a pair of Lexan scissors. Go slowly, cutting out the wheel wells and any excess plastic around the body. Any rough spots can be smoothed out with a Dremel sanding drum.
This will remove dust from sanding and any residue leftover from when the body was cast. Both of these will prevent the paint from properly adhering.3. Apply the window masking to the inside of the body where the windows should be. Painter's tape will work here further if your body did not come with masking. Make sure that the masking or painter's tape is pushed firmly onto the body to prevent the paint from seeping underneath and getting onto your windows. If you would like other designs on your car's body such as racing stripes, use painter's or masking tape to mark them very.
6. Drill holes for the body mounting posts with a drill bit or cone-shaped sanding bit.
