The brake calipers on the Chevy appropriateness hydraulics to squeeze the rotor between the brake pads to site the machine. Whether they are not functioning properly, the vehicle Testament not mark. Signs of a poor brake caliper add leaking enclosing the caliper piston, the van seeming to pull to one side when braking, or the brake pads seeming to wear quickly and unevenly whereas the calipers are not operating properly. An guideline adult can quarters a brake caliper in approximately 30 minutes. Whether you gem yourself replacing the brake calipers on your Chevy, be undeniable to interchange the pads further whether they are worn.
Instructions
1. Establish the crackerjack cylinder on the Chauffeur's side of the firewall in the engine compartment. Remove the comprehend and empty the brake fluid from it using the turkey baster. Accommodation the fluid in the withdraw pan for succeeding recycling. Levy a allot of circle chocks extreme the rear wheels of the Chevy. Stand the Chevy on the side you are starting with, using the vehivle jack.
2. Deposit a jack under the Chevy near the jacking mark and elevate it to the frame of the vehicle. Loosen the lug nuts with a lug wrench and remove the revolve from the vehicle. Remove the brake hose from the leading brake path using a wrench. Remove the brake hose from the caliper using a wrench to remove the bolt.
3. Loosen the brake caliper bolts using a hex socket and ratchet. Lift the caliper out from the turn assembly. Remove the brake pads from the caliper and discard them if they are worn. Connect the new brake hose to the caliper. Tighten the bolt using a wrench. Insert the brake pads and place the brake caliper on the mounting cradle on the wheel assembly.
Repeat the procedure on the other wheel.5. Fill the master cylinder with fresh brake fluid when the project is complete. Place the tire on the Chevy and tighten the lug nuts with a lug wrench. Remove the jack stand from under the vehicle. Lower the Chevy to the ground.4. Connect the brake hose to the main brake line and tighten the fitting with a wrench. Tighten the caliper bolts using a hex socket and ratchet.
Bleed the air out of the brake lines by having an assistant pump the brake several times and hold them while you open the bleeder valve on the wheel with a wrench to expel the air in the lines. Repeat the process until all air is out of the brake lines.
