Moderate the 2003 Silverado's Brake Pads
The 2003 Chevy Silverado's are ½-ton pickups comprehensive with four-wheel CD brakes. The Silverado brake step consists of the hydraulic proficient cylinder, brake lines, calipers, pads and rotors. While the adept cylinder, lines and calipers should at the end the activity of the Silverado, Chevy designed the pads and rotors to wear away as bit of their role in stopping the Motor lorry. Whether your brake pads are below 3 mm thick, and you acquire basic auto-repair contact, moderate them nowadays. Otherwise, grip the Motor lorry to a trusted mechanic To possess the drudgery performed.
Instructions
1. Loosen the front lug nuts with the lug wrench. Push the turn chocks against the back and front of the right-rear tire to dominance the Motor lorry in community.
3. Settle the drip pan under the Silverado's left-front brake. Disinfected the brake dust off the caliper and rotor surfaces with brake cleaner spray.
2. Lift the Silverado's front confine with your floor jack. Lower it onto the jack stands. Booty the lug nuts and wheels off by plam.
4. Remove the caliper mounting bolts with a socket place. Pull the caliper away of the mount by plam and then remove the brake pads from the caliper manually.
5. Wash absent the inside of the caliper using brake cleaner. Make sure to clean all the gunk and brake dust off the pistons and caliper slides. Lube the slides thoroughly with white lithium grease.
6. Retract the caliper pistons with the caliper tool and then install the new brake pads. Drop the caliper back into the mount and bolt it in with the socket set.
7. Move over to the other side and repeat steps 3 through 7 on the right-front brakes. Put the wheels and lug nuts back on the Silverado when done.
8. Lower the truck off the jack stands, move the wheel chocks to the right-front tire and repeat steps 1 through 7 on the back of the truck.
9. Use your torque wrench to tighten all the lug nuts to 140 foot-pounds.
