Directions on Remove a Toyota Tacoma Door Panel
3. Pry off the covers over the two screws on the arm rest to access them. Remove the screws and pull the arm rest off the door. This article applies specifically to 1995-2004 Tacomas, however should commission for sequential models too.
Instructions
1. Disconnect the refusal battery cable. This is exclusively influential whether your Tacoma has capacity windows and doors, however is something that you should always arrange when working on the Motor lorry.
2. Skip To pace 3 provided you hold aptitude windows. Cover a shop towel between the stem and door of your Tacoma with guidebook windows. Pull up on the towel at the purpose where the crank connects to the door to Proceeds the snap phone. Remove the snap call and pull the knob straight off of its shaft.
The door panel of a Toyota Tacoma serves the dual belief of protecting components located inside the door, such as the window and door hasp mechanisms, and providing a mounting end for items such as the widow controls and door lock mechanisms. You must remove the door panel to access these components. The exact procedure Testament differ, depending on if you Tacoma is equipped with influence or textbook windows and locks.
4. Remove the unmarried screw that attaches the handle to the door. Slide the handle toward the front of the truck to remove it.
5. Remove the power window/lock panel if you have one, by carefully prying it up on both sides. Pull it out of the door and disconnect the electrical connector.
6. Use an Allen wrench to remove the single trim panel screw at the top-front edge of the trim panel.
7. Insert a flat object, such as a screwdriver or putty knife, between the trim panel and the door frame, to pry off the panel. There are 12 retainer clips to disconnect, four each on the left and right sides and the panel bottom. Pull the trim panel free from the door.
8. Access the door's inner parts by peeling back the plastic water shield.
