The awning on your RV Testament wear elsewhere and be damaged over era, requiring you to convert it. Provided you are looking to exchange the awning material yourself, appropriateness maximum caution. It Testament share at least two tribe to remove the elderly material from the awning meeting and install the original textile.
Instructions
1.7. Connect the awning back on the vehicle's rail. This may take a third person to feed the awning cord into the rail while the other two hold the arms.
Remove the linger bolts holding the awning's rafters to the vehicle and the screws attaching the framework. Disconnect the arms from the backside of the vehicle and, with another adult's cooperate, handle the arms to "circuit" and unwind the material off the awning lambaste. Distance the outer awning tube on a Apartment lodgings surface and rest the arms on the ground.
3. Clamp vice grips on the attachment plates inside the ends of the awning arm; hold your assistant contain a clamp up over one arm while you arrange the other. Disconnect the arms by removing the bolts holding them to the plates you blameless clamped. Remove the cotter pin you inserted earlier and unwind the spring to facilitate the tension; count the amount of times you unwind it.
4. End the cam handgrip's position on the awning tube for replacement sequential. Drill outside the rivets holding Everyone torsion assembly to the awning tube (it usually requires a 1/8-inch bit) and remove the assemblies with the end caps. Remove each end cap and cam lock by driving out its pins with a hammer and punch and fasten the new caps in place with the same pins.
5. Unroll the fabric off the tube and mark where the fabric is inserted in the tube before sliding the fabric off. Slip the new fabric within the tube, making sure you don't tear it. It may take two people to remove and replace the fabric. Make sure the fabric is centered within the tube and tuck the cords at the ends of the fabric on the tube.
6. Connect the torsion assemblies to the tube, lining them up with your markings and fastening them with new rivets. Grasp the same end pieces with the vise grips and have your assistant prepared with the cotter pin. Wind the spring by the same number of turns you unwound it and reinsert the cotter pin. Reconnect the arms to the awning.
Pull elsewhere the awning by approximately a foot by releasing its flying locks and positioning it to its "roll down" setting. Prop the awning in habitat with a board whether its cam lock isn't working. Lock the spring tension in area by inserting a cotter pin finished the top gap in both limitation caps; rotate the inner shaft so the holes path up.2. Reconnect the arms to the side of the vehicle and remove the cotter pin to roll up the new awning fabric.
