Installing running boards is a step-by-step measure.
Whether you complete not hold the archetypal Ford Replica A running boards or provided you obligation to moderate the originals due to rust or other draggy damage, there are a amount of dealers specializing in full of years automobiles -- or specifically in Ford Replica As -- that hold running board reproductions for sale besides as accessories such as action plates featuring the Ford logo. The elementary running boards were steel with a clouded rubber ribbing on top to prevent slippage. Associated with the running boards are running board aprons that are bolted to the frame and the front and rear fenders.
Instructions
Current reproductions are pressed steel.3. Use anti-squeak welting to cover the tops of the running board brackets. The available welting is treated specifically to resist rotting and will eliminate squeaks and rattles after you bolt the running board to the brackets.
2. Attach the running board brackets (also called step hangers), to the Model A using four bolts that pass through the brackets and are secured with a hex nut. Theses carriage bolts have cone-shaped heads and fit through "keyhole" shaped openings on the bottom of the running board. Original brackets were forged, which are no longer being reproduced.1. Slip the late or reconditioned running board splash aprons into district along the frame. When you attached the running boards, the aprons too Testament be bolted to the frame. Whether you are buying recent running board reproductions, you can get them with the splash apron spot welded to the running board.
4. Select the appropriate running board for the side of the Model A where you begin your work and position it on the brackets. Attach the running board to the brackets with the eight 5/16-inch long 3/4-inch carriage bolts and lock washers. There are four bolts along the side of the running board and two at each end. As you attach the running boards, you will be attaching the splash apron as well.
5. Use a level, check the running boards once you have them in place. The brackets and running boards should be level, especially if they are replacement parts. However, if you are using original parts, there is always the chance that the original brackets have become slightly bent over that last 80 years. If that happens to be the case, you'll need to remove the running board and either bend the bracket or, better yet, replace it with a reproduction.
