The dual radiator fans on your Neon job in tandem to quickly gelid the coolant within the radiator. One or both of them may metamorphose dangerous over date from Day-to-day cause. Damage to the fans most ofttimes happens from a loose wire connexion. The fans can too be damaged from debris that builds up on their blades. This can arrange the immature motors on Everyone of the fans overwork seeing the blades are heavier than commonplace. Typically, whether one of the fans stops working the other one Testament soon fail besides. Then, you should remove and modify both of them at the corresponding period.
Instructions
2. Loosen and remove the balky battery cable with a socket wrench. Position the cable completely out from its announce and any other metal.
1. Govern the Chauffeur's door and operate the emergency brake. Pull the hood Proceeds lever. Uplift and flotation the Neon's hood.
3. Hoist the front-end of the machine with a hydraulic jack. Put a jack stand on Everyone side of the front stop at the end the front tires, unbefitting the frame rail. Lower the hydraulic jack until the car rests on the jack stands.
4. Slide under the front of the car beneath the radiator. Remove the two bolts on the bottom of the radiator fan assembly with a socket wrench.
5. Reach up into the engine compartment and unplug the wiring harness connected to each of the fans. Remove the wiring harnesses from the retaining tabs along both sides of the fan assembly.
6. Raise the Neon with the hydraulic jack. Remove the jack stands. Lower the Neon to the ground. Remove the hydraulic jack.
7. Remove the four securing bolts along the top of the radiator fan assembly with your socket wrench. Lift the fan assembly vertically out of the engine and set it down on a flat working area.
8. Remove the nut holding the fan blades in place on the motor's shaft with your socket wrench. Remove the three bolts at the rear of the fan assembly that hold the motor in place with your socket wrench. Lift the defective fan motor out of the assembly and discard it. Save the fan blades to reinstall on the new motor if they're still in good shape.
