The ignition transaction starts with the chief.
This is the negative cable. Label the negative leads with masking tape. This will make installation easier.6. Loosen the remaining nut to remove the positive leads. Once the starter goes poor, it Testament extremity to be replaced. The starter is located under the machine at the rear of the engine and changing it elsewhere should not capture as well enduring.
Instructions
1. Grounds the automobile on a Apartment lodgings, yet surface. Establish the parking brake.
2. Emptied the hood to access the engine compartment. Disconnect the battery by unbolting the absent and persuaded terminals with a socket wrench.
3. Field a jack under the front beam of the vehivle. Uplift the automobile flying Sufficiently to accommodation jack stands under the axles. Lower the machine to the jack stands. This Testament own quota of interval to access the starter.
4. Allot the starter on the underside of the automobile on the passenger side. The starter is between the engine and the transmission.
5. Loosen the kernel on the top stud of the solenoid with a socket wrench.The ignition method in the Ford Mustang starts with the keys. Inserting the interpretation in the ignition sends an electric locution to the starter. The starter engages the flywheel. The flywheel engages the crankshaft and the automobile remains running until the crucial is turned to the "Off" position.
This will isolate the electrical lines from the starter.
7. Unscrew the three bolts with a socket wrench. This will loosen the starter from the frame. Slide the starter off the frame. Place the starter in the box that the new starter came in.
8. Mount the new starter to the frame. Tighten all three bolts with the socket wrench.
9. Unscrew the bottom nut on the solenoid. Place the positive lead on the stud. Tighten the nut on the stud with the socket wrench.
10. Unscrew the top nut on the solenoid. Peel the masking tape off the negative cable. Place the negative cable on the stud. Tighten the nut with the socket wrench.
11. Raise the car with the jack. Pull the jack stands away from the car. Lower the car to the ground.
12. Connect the positive and negative cables to the battery with the socket wrench. Ensure both cables are tight.
13. Start the car to ensure the starter is working adequately.
