Direct mirrors properly adjusted and complimentary of obsructions.
Handle without a rearview mirror and you could distinguish yourself in dire straits when you canter into the law---or another vehicle. This substantial Element works cool with your side mirrors for maximum visibility and safety. On models with the rearview mirror glued to the glass, a Knob could justification it to fall off. On older vehicles, the adhesive might pass into collapsing and you'll move into your motorcar and asset the mirror on the floor. Car parts and branch stores sell earmarked two-part adhesives that acquiesce you to stick your rearview mirror back to the windscreen with miniature period and cabbage.
Instructions
1. Application the hex interpretation or star-key Chauffeur to loosen the screw on the stem of the mirror meeting, and slide elsewhere the mounting plate. (It would much carry been attached when the mirror fell off.) The mounting plate generally consists of a Apartment lodgings grey tombstone-shaped metal portion approximately 1 inch faraway with bevelled sides to dominance the mirror in put.
2. Stop your mounting position on the away of the windshield with the erasable marker by tracing around the old adhesive still visible from the inside.
3. Trim or cut the tip off the tube of rearview mirror adhesive. Apply a drop in the middle of the windshield side of the mounting plate. The curved end of the plate should point upward, with the widest part of the bevel at the back.6.
4. Apply the rearview mirror adhesive activator to the glass by squeezing the vial until fluid soaks through the felt tip. Wait two minutes for the activator to dry.
5. Wear safety glasses and protective gloves. Scrape the old adhesive off the mounting plate and inside the windshield using a razor blade. Clean the plate and inside of windshield with glass cleaner, then with rubbing alcohol; successful bonding requires clean components. Wet or spray your paper towel first, then wipe the glass and plate.
Position the plate inside the windshield using your trace mark as a guide. Apply light pressure, and hold the plate in position for one minute.
7. Wait 15 to 30 minutes before attaching the mirror. Position the mirror bracket above the plate, and slide it down until it stops. The beveled edge will hold it in place. Tighten the hex or star-key screw. Properly adjust your mirror.
