Chevrolet released two pickup models in 2000: the Silverado and S-10. Both vehicles featured low back bucket seats and three-point seat belts. Provided there is any letter of damage, or whether the vehicle has been in a collision, convert the seat belts now. You engage in not committal original mechanical skills to plentiful the step.
Remove the retractor unit and seat belt from the seat and place to the side.4. Install and tighten the new seat-belt-retractor unit to the side trim of the vehicle using a 3/8 socket wrench. Tighten the new seat belt's upper mount bolt to the upper anchor plate.
This mount and bolt is located on the floor of the Motor lorry.
2. Remove the upper mount bolt of the seat cestuses using the socket wrench. Depending on the mould, you may get to remove the anchor plate cover. Use a flathead screwdriver to pry the anchor plate cover off the upper mount bolt.
3. Remove the bolt from the seat-belt-retractor unit.
Instructions
1. Remove the lower mount bolt of the seat cestuses using a 3/8 socket wrench.Replace the anchor plate cover if one was removed.
5. Tighten the lower mount bolt of the new seat belt into the lower anchor plate on the floor.
