Otto Bernz founded the BernzOmatic hand-held torch and finery collection in 1876. This if the home-owning handyman a portable choice for at rest improvement without having to grip professional-grade contractors to bring cumbersome oxyacetylene torches to the stop. The hand-held torches action a even also regional advantage than known grade torches, nevertheless many tasks can be achieved by the account of the portable propane torch. In 1982, the BernzOmatic Firm became a division of the Newell Rubbermaid Corporation.
Instructions
1. Recite the owner's tome and safety jotter from contain to comprehend before attempting to appliance the torch or torch gratuity with a portable receptacle.
2. Practise the torch utensils per instruction volume. Some kits come comprehensive with the torch gratuity and receptacle, and some kits simply come as a self-igniting torch tendency that can be screwed onto a portable propane receptacle. Be undeniable the torch gratuity has a tight seal to the container.
3. Assign on the safety glasses and objective the torch gratuity out from you.
4. Annex the striker ready provided relevant. Most of nowadays's BernzOmatic propane torches own self ignitors. Once the gas is turned on for the manual lighting torch, place the end near the edge of the torch tip and strike. The spark will instantly ignite the propane gas emitting from the cylinder. For self-igniting torch tips, turn the gas valve on to full open. You will hear the propane dispensing from the cylinder. Hold down the trigger safety button and pull the trigger. It may take a couple of clicks from the trigger to ignite. If you are unsuccessful lighting the self-igniting tip, turn off the propane and allow a couple of minutes to air out the area before reattempting.
5. Adjust the flame of the torch to desired height and intensity by turning the gas valve clockwise or counterclockwise.
6. It is recommended to disassemble the torch head or the torch kit once it has cooled down for safety reasons. If heating metal connections to expand and remove, heat the intended nut only, or heat the area around the bolt only. Heating the entire area will only expand the metal of the connecting component you're trying to remove the nut or bolt from and you will be unsuccessful.
7. Turn the gas valve to off and make sure it is all the way off when you're done using it. Place the tip of the flame to the intended object. If soldering, the flame should be small and the solder placed into the blue of the flame. If sweating, a higher flame can be used, but further away from the pipes to sweat slowly.
