Decrease an Aluminium Diamond Plate With a Sawzall
A Sawzall, or reciprocating aphorism, uses a pushing and pulling moving to fall a blade fini info. For this basis, you committal to wages especial carefulness when cutting aluminium with the Sawzall, as this progress can account the aluminium diamond plate to vibrate. This can discontinuity the Sawzall blade, damage the aluminum diamond plate and the Sawzall blade does not incision while the aluminium diamond plate is jumping. Securing the diamond plate Testament eliminate vibration and jumping, production the chore easier to administer.
Instructions
1. Lay on your safety glasses and hide daily grind gloves.
2. Levy the aluminium diamond plate Apartment lodgings on top of the worktable and slide the decrease where you must to chop over the path of the worktable.
3. Secure the aluminum diamond plate to the worktable get clamping it in place with the two pairs of self-locking C-clamps. Place a pair of C-clamps at each side of the aluminum diamond plate, where the side of the plate and the edge of the worktable meet.
4. Insert the 14 TPI Sawzall blade into the Sawzall. Refer to the Sawzall operating manual to determine the procedure for securing the blade to the head of the Sawzall.
5. Place the edge of the Sawzall blade onto the aluminum diamond plate, tilt the back of the Sawzall down and press the trigger of the Sawzall to begin cutting the aluminum plate.
6. Slowly cut across the aluminum diamond plate, ensuring that the back of the Sawzall remains tilted toward the aluminum diamond plate. Repeat the procedure for each cut you need to make on the aluminum diamond plate with the Sawzall.
Attach the four-inch diameter flapper wheel to the four-inch grinder.
9. Run the grinder along the cut edge of the aluminum diamond plate to remove the burr left by the Sawzall blade.
10. Release the self-locking C-clamps from the aluminum plate.
11. Do not stand the Sawzall vertical, as you will not be able to control the Sawzall blade and the cut will not be straight.7. Support the piece of aluminum plate overhanging the edge of the worktable with one hand as you come to the far side of the cut.8.
