The doors and the ignition switch in your motorcar end lock cylinders that grind with your keys. Whether you interchange a lock cylinder, you demand to pocket money the solution also. A latest lock cylinder should embrace its own decisive. Provided you are changing a door's cylinder, nickels all of them so they adoption the alike explanation.
Instructions
Ignition
1. Disconnect the motorcar's bad battery cable.
2. Remove the covers from the steering line, normally by removing the screws holding the lower encompass in country and then separating the two covers.
3. Subsume the ignition solution into the cylinder, forming positive the vehicle is in Stadium provided it has automatic transmission. Turn the basic so it is in the "Dash" or "Exit" position.
4. Allot a gap in the lock cylinder, subsume a bitty screwdriver or drill bit into the gap to Proceeds the detent or retainer and pull out the cylinder.
5. Remove the mounting bolts or other fasteners for the door handle and remove it; this can require a screwdriver or wrench depending on the model.10. Remove the fasteners for the lock cylinder and remove it.
Doors
7. Disconnect the door's inner trim panel. Remove the window crank by rubbing a towel behind it to disconnect its clip, or pry out the power controls with a trim stick and disconnect their connectors. Locate and remove all the retaining screws on the panel, then lift the panel off its clips and disconnect all electrical connectors from behind it. Peel back the watershield.
8. Detach the actuating rods for the door handle and the lock cylinder. Disconnect any electrical connectors that are in the way of the door handle and cylinder.
9. Insert the key for the new lock cylinder into that cylinder and insert the cylinder into the steering column, aligning it so the cylinder and key will be in the "Run" position. Push the cylinder in place until you hear the retainer click into place, then turn the switch to the "Off" position.6. Reconnect the covers for the steering column and the negative battery cable.
You may need a pliers to pry it out.
11. Insert the new lock cylinder and apply the fasteners.
12. Reconnect the door handle and the other parts in the reverse order of removal.
