Many of the sizeable Briggs & Stratton engines are these days equipped with electric starters. These starters are normally low concervation, on the other hand after dotage of operate, they can wear elsewhere. The brushes are used to bear the electrical contemporary from the battery to the engine's rotor. Whether the brushes fail, the starter Testament not turn. Replacing brushes can be a cheaper thought than buying a contemporary starter, provided the brushes are identified as the dispute.
Instructions
1. Complete this slowly by reason of the brushes may pop gone.3. Push the spring for the fundamental brush holder back into the holder. While holding that spring in country, push a advanced brush into the holder.
Remove the starter bolts holding the starter on to the engine. Then remove the starter and dwelling it on a effort table. Remove the screws holding the starter back plate in put. Disconnect the black negative battery cable at the battery. Remove the bolts holding the flywheel involve in habitat. Disconnect the blush confident wire connected to the starter.2.
Hold the brush in place and insert a safety pin through the brush holder pinhole located on the back of the end plate. This hole lets the safety pin hold the new brushes in place when the end plate is reinstalled.
4. Repeat the above procedure for the second brush holder. Reinstall the starter end plate and tighten the end plate screws. Pull the two safety pins from the back of the end plate to release the new brushes. Reattach the starter and the red starter wire. Reconnect the black negative battery cable, and test the starter by turning the ignition switch to the "Start" position. The starter motor should spin.
