A vehivle alarm can discourage a thief from stealing a car--but so can a affected van alarm, whether the thief thinks it is concrete. Besides regularly than not, the flashing glowing indicative of a vehivle alarm moves a thief on to a machine without an alarm. A concocted vehivle alarm is simply a flashing brilliance that looks allying a existent machine alarm burnished. It individual costs approximately 5 dollars and a time of your period To erect a realistic artificial van alarm that automatically flashes when the motorcar is turned off and stops flashing when the van is turned on.
Instructions
1. Disconnect the van battery cables from the battery. Remove the contravening cable front. To remove the battery cables, loosen the screw on the cable using a screwdriver. Once the screw is loosened, the cable Testament easily pull off the battery advise.
2. Strip 2 inches off the ends of the flying lead wires that are attached to your LED flashing using a wire stripper. Strip one wire at a continuance. To employ the wire stripper, quick the belongings sorrounding the wire approximately 2 inches from the location of the wire. Holding the wire stripper tightly closed, pull the thing In relation to the speck of the wire. The wire stripper Testament pull the plastic coating off the wire.
3. Wrap the blush flying bob wire enclosing the cocksure battery terminal cable. The wire should be wrapped approximately the battery cable screw that you loosened when removing the battery cables.
4. Bound the chestnut and charcoal cables along the side of the engine compartment and push them finished so that they fall underneath the dashboard. Avail electrical tape to tape the wires to the sides of the engine compartment so they don't shift.
5. Inspire access to the motorcar ignition by removing the ignition housing. Access to van ignitions differs according to the automobile pattern. The top groove to good buy access to the ignition of your machine is to flash in your van's guidebook. Once you have access to the car ignition, you are ready to move on to the next step.
6. Most cars have dummy panels in the dashboard. Dummy panels are sections that pop out of the dashboard without having to remove the actual dashboard. If your car does not have a dummy panel or if you cannot figure out pop out a dummy panel, refer to the car repair manual.
8. Twist the black flying lead lighter that is attached to the LED to the 12-volt positive ignition wire.
9. Wrap electrical tape around the section of twisted black flying lead and ignition wires.
10. Pop out the dashboard dummy panel where you want the LED light to display. Locate the 12-volt positive ignition wire. To determine this wire, refer to the car repair manual.7. Strip 2 inches off of the end of the 12-volt ignition wire using a wire stripper tool.
11. Using a drill and bit, drill a hole in the removed dummy panel. Use a bit that will drill a hole that is the same size as the LED light.
12. Put the LED light into the dummy panel. The LED should slide into the hole from the back of the dummy panel so that it is sticking out of the front of the dummy panel. Pop the dummy panel back into the dashboard.
13. Put the battery cables back onto the battery, starting with the positive cable. Put the positive cable onto the battery post and tighten the cable screw until the cable is tight on the post. Then put the negative cable on using the same method.
14. Test the fake car alarm. With the car ignition turned off, the LED light should flash. When the car ignition is turned on, the LED should turn off. If the fake car alarm is not working, go back and check all of your steps to make sure that all the wires are correctly connected.
15. Replace the ignition housing.
