Replacing brake calipers on a Hyundai Santa Fe SUV is no baby occupation. It's much besides convoluted than most vehicles thanks to the Santa Fe comes with an anti-lock braking transaction. Since of this, bleeding the braking system after replacement is even augmented explicit.
Instructions
Replacing the Caliper
1. Remove the rotate from the vehicle after lifting it onto the jack. Flash on to manipulate the "five star" design on the lug nuts, removing the one across from the one you formerly removed.
2. Detach the brake hose from the caliper. Toss elsewhere the washers used with the becoming bolt and plug the brake string with a quantity of rubber.
3. Disconnect the caliper mounting bolts and remove the caliper. It should rotate upward on the boot pin and then slide off.
4. Install the advanced caliper, sliding it into the pin boot carefully and pivoting it down onto the bracket or rotor.10. Wait one minute until you operate the air bleeding. Pump the brake pedal several times until fluid runs out without bubbles when you loosen the bleeder screw.
6. Bleed the anti-lock brake transaction. You must advantage a Hi-Scan Pro Slogan for Hyundai vehicles to determine this.
7. Habitat the revolve back on and lower the vehicle. Appraisal the brakes, antecedent by pumping them for firmness while stopped and then while driving.
Bleeding the Brake System
8. Connect a autonomous plastic tube to the turn cylinder's bleeder plug with the other heel in a half-filled halcyon plastic bottle. Connect a Hi-Scan Pro Slogan to the data link connector under the dash panel.
9. Select Hyundai vehicle diagnosis" on the Hi-Scan device, then the vehicle name, "Anti-Lock Brake system" and "air bleeding mode." Press "yes" for operating the motor pump and solenoid valve.
Tighten the caliper bolts to 58 foot pounds to 73 foot pounds for a front caliper and 37 foot pounds to 44 foot pounds on a rear caliper.5. Reconnect the brake hose, using contemporary washers with the becoming bolt. Tighten the bolt to 18 foot pounds to 22 foot pounds.
