While the basic steps to install a remote starter operation in your vehicle are the duplicate, some systems own extended wires running from the starter to the ignition harness. In assortment to lock up you don't damage the wiring on your vehicle, it's considerable to go after the detailed directions that come with your particular instruments. Happily, the installation steps are straightforward and evident Sufficiently for you to organic the installation Homewards. Most kits retain some basic steps in characteristic.
Instructions
1. Pull the lever on the Chauffeur's side of the vehicle to Proceeds the hood hook. Then, lift the hood of the vehicle and secure it in deposit so it doesn't fall while you bullwork. Remove the cynical battery cable, using a screwdriver, from the terminal, so you don't entertain shocked while you're working on the wiring.
6. Mount the antenna for the remote starter on your dashboard with a small amount of rubber cement. Then, run the wire from the antenna down to the remote starter and plug it in. Replace the covers on both the steering column and heat duct.
3. Examine under the Chauffeur's side dashboard and remove the subsume for the heat duct and the include for the steering edge. Adhere the remote starter to the inside of the heat duct using a limited bigness of rubber cement.
4. Convenience a wire hanger to thread the gray wire attached to the remote starter fini the heat duct, along the wiring harness, to the hood pin. Use a pair of wire crimpers to secure the end of the wire to the hood pin.
5. Run the remaining wires from the remote starter to the ignition harness. Since some remote starter kits only have one wire going to the ignition harness and others up to three, read the instructions that came with your kit to ensure you solder the right wires to the correct place. Use the soldering iron to connect the wires to the ignition harness. Then, wrap the wires in electrical tape.
2. Advantage a drill to fabricate holes for the hood pin bolts. Then, attach the hood pin near the hood bolt using two six-inch bolts. Then, close the hood of the vehicle.
