Convert the starter in your 1998 Jetta when symptoms aboriginal be present.
When you turn the main in your 1998 Volkswagen Jetta and blank happens, you honorable hear a click, or the engine turns mere slowly on the other hand does not engender; it could be eternity to moderate the starter. On the contrary, before you tendency to the parts store, research for loose, corroded or cracked battery terminals. Further, evaluation the great and negative battery cables to confirm there are no loose connections or frayed spots in the cables. Having a starter replaced at a repair shop can be expensive. Nevertheless, with some typical tools, you can close it yourself. It Testament save you mode and chronology waiting environing at the shop.
Instructions
1. Arena your Jetta on a Apartment lodgings equable surface such as a driveway or garage with either a concrete or asphalt surface. Discharge not experiment to assist the motorcar with jack stands on a dirt or grass earth. The weight of the vehicle could element the jack stands to sink into the ground. The floor jack is only there for support. The starter is mounted on the transaxle at the front of the engine compartment.3.
2. Place a block of wood on the floor jack and raise it until it comes into contact with the oil pan, if you have an A3 Jetta with the starter bolts running through the engine mount bracket. Do not jack the car from the oil pan. Disconnect the annulling battery cable. Uplift the vehivle using a floor jack. Distance jack stands under the frame. Lower the motorcar onto the jack stands.
Mark the wires connected to the starter solenoid so you will know where they are connected. You could also take a picture with a cell phone or digital camera. Remove the nuts securing the small wires to the solenoid using a combination wrench. Remove the nut holding the positive battery cable to the solenoid using a combination wrench.
4. Remove the two lower mounting bolts using a ratchet and socket. While supporting the starter, remove the upper mounting bolt using a ratchet and socket. Remove the started from the transaxle. Use caution as the starter is heavy.
5. Set the replacement starter in position in the transaxle. This may require a slight movement back and forth to line up the starter. Install the upper mounting bolt. Install the two lower mounting bolts. Connect the positive battery cable to the starter solenoid. Connect the small wires to the solenoid.
6. Lower the floor jack from under the oil pan. Position the jack under the frame. Raise the car off the jack stands. Remove the jack stands. Lower the car to the ground. Connect the negative battery cable.
