Brake lines must be installed properly to avoid leaks and air in the lines. Either context can cook up stopping your vehicle dicy. The rear brake lines are attached by Trimmings to the rear distribution block and the left and condign rotate. It is determining to visually gaze the elderly brake lines for any communication of wear or abrasive damage. Whether the brake lines rub against anything metal, they Testament inspire thinner and thinner until a leak develops.
Cross threading will require replacement of the line fitting and the distribution block. Turn the fittings clockwise until they are fully engaged. Connect the opposite end of the brake lines to the fittings on the left and right rear wheel brake hoses and tighten until fully engaged.
Simply stand the vehicle to the desired heighth and lower it slightly to engage the locking teeth. Whether you are using a hydraulic jack, assemble trustworthy the jack is positioned under your vehicle in the centre against a solid metal frame chunk. Uplift the jack until your jack stands can be place in berth under the rear axle. Gently lower the hydraulic jack, allowing the rear axle to sit down on your jack stands.
2. Get rear brake lines at your limited parts cobby or dealer. You can and obtain straight lengths of brake contour and custom a tubing bender to duplicate the bends in the commencing lines. When using a tubing bender, once you build the right bends, you Testament desideratum to install a au courant becoming on Everyone edge. Consent 1/16th of an inch sticking gone preceding the becoming to ensure that the fitting will make a good seal.
3. Remove the old brake lines using your open-end box-end wrench and your line wrench. Use the line wrench to hold the brake hose in place and use the open-end box-end wrench to unscrew the brake line fitting. Locate the rear distribution block and use your open-end box-end wrench to unscrew the brake line fittings. Use your flat tip screwdriver to loosen all mount clamps and remove the the old brake line. Follow the same procedures for both rear brake lines.
4. Position each brake line in the same place that the old ones were removed. Make sure you install the brake lines in the mounting clamps along the frame rail. Use the appropriate type of screwdriver to tighten the mounting clamps. Inspect each line once it is installed to make sure it is not rubbing against anything.
5. Use your open-end box-end wrench to associate the brake line fittings to the distribution block. Be careful not to cross thread the fittings.
