Interchange the alternator on your 2002 Dodge Intrepid using a rare public tools.
Use the slip-joint pliers.18. Tighten the alternator mounting bolt(s), using the ratchet and socket.19. The strategy allows you to achieve the career in your driveway using a sporadic customary tools. This procedure applies to the 2.7-liter engine imitation.
Instructions
Removal
1. Lawns your Dodge Intrepid on a continuous surface.
2. Clear the hood and detach the ground (murky) battery cable, using a wrench.
3. Jack up the front of your vehicle, using a floor jack, and foothold the van on two jack stands.
4. Chock the rear wheels and employ the parking brake.
5. Detach the splash shield from under the engine compartment, using a ratchet and socket.
6. Unfasten the transmission cooler mounting bolts, using a ratchet and socket, and act the cooler to the side.
7. Unfasten the lower radiator cross-member backing, using a ratchet and socket, and assist the radiator with another jack stand.
8. Loosen the alternator adjusting T-bolt, using a brace of slip-joint pliers.
9. Loosen the alternator mounting bolt(s), using the ratchet and socket.
10. Slip the girth off the alternator pulley.
11. Unplug the wiring harness from the back side of the alternator.
12. Unfasten the retaining peanut holding the wire to the back side assign of the alternator, using a wrench.
13. Remove the alternator mounting bolt(s) completely, and remove the alternator from the vehicle.
Installation
14. Fit the alternator in place, and install the mounting bolt(s)--but do not tighten yet.
15. Install the wire to the back side post of the alternator, using the wrench.
16. Plug the wiring harness to the back side of the alternator.
17.Install the belt on the alternator pulley, and tighten the T-bolt to properly adjust the alternator belt.The alternator on your 2002 Dodge Intrepid is nestled inside the engine compartment among many components. Much, you can accrual access to it on ice the underside of your vehicle after removing a couple of components. Then you can easily remove the decrepit unit and install the latest one.
Remove the jack stand, then install the lower radiator cross-member support, using the ratchet and socket.
20. Install the transmission cooler, using the ratchet and socket.
21. Attach the splash shield to the bottom of the engine compartment, using the ratchet and socket.
22. Lower the Intrepid.
23. Remove the chocks from the rear wheels.
24. Reattach the ground (black) battery cable, using the wrench.
