You can install a Hollandia sunroof with a uncommon tools.
Having a sunroof as tool of your vehicle allows you to receive additional glowing inside of the cab and empiricism the extended air rushing on ice the van as you cruise down the highway. Purchasing a vehivle with a sunroof can be expensive, but, it is credible to install a sunroof yourself after you shop for the vehicle. The Hollandia sunroof is a example that you can pay for and install on your vehicle in an afternoon of Leisure time.
Instructions
1. Country the trimshell on the roof on the interior of the machine where you demand the sunroof to be positioned. Include the Brad-awl nailed down the spot striking "Reference Purpose B" so that it is sticking completed the roof of the vehicle. Berth the paper template on the exterior so that "Reference Location B" is aligned with the Brad-awl and tape the template down. Remove the Brad-awl.
2. Convenience the function drill and a 5-mm bit to drill three holes concluded the roof at the points noted on the paper template.
3. Chop gone the interior template from the cardboard box the unit was shipped in. Capitalization the aptitude drill to incorporate screws in concluded the clear holes to secure the interior template to the roof, lining up "Reference Point B" with the hole left from the awl. Use the knife to chop the headliner around the template and remove the section of headliner along with any insulation material inside.
4. Use the power saw to chop out a section of your vehicle's roof. Follow the guidelines on the paper template on the top of the roof. Remove the section when cutting is complete and you should have a clear passage to the interior of the car. Gently place the sunroof into the opening.
6. Connect the red wire coming from the sunroof to the positive battery terminal on your vehicle. Connect the red and black wire to the positive terminal on your vehicles ignition switch and connect the green wire to a bare piece of metal to create a ground.
5. Attach the front part of the clamp frame to the front of the sunroof and lift it up so it is flush with the ceiling. Place the mounting screws in the middle holes of the clamp frame, followed by the front then the rear.
7. Place the motor and control unit into the opening on the front of the sunroof. Slide the spline of the motor shaft into the exposed gearwheel. When the motor is in place, place the trimshell over the motor and the clamp frame and mount it by inserting mounting screws into the holes on the front and back.
