Your RV soak heater typically holds 6 to 10 gallons of saturate. In adjustment to prevent having to fill your water heater completely with antifreeze during winterization, you can install a bypass is to eliminate the flood heater from the RV plumbing progression, and so both the broiling and cold water systems are tied calm. This makes de-winterizing yet easier.
Instructions
1.4. Install the second valve in a similar manner. Note that the valve handles should be on the opposite sides of the tubing. That is, if the valve is facing to the right, the other valve handle should be facing to the left. First off remove the empty plug at the backside of the cistern. Receipts interest to quickly remove the plug once the remain thread is reached and development to the side, otherwise you'll be in for a pleasant soaking. The plug can sometimes keep a extensive rod (called an anode rod) attached to it; whether so, you'll carry to pull it away a ways to remove it. Let the vat extract completely.
2. Fix the imbue heater inside your RV. Most recurrently, it is located inside a bake house Private room or under a dinette. Remove any drawers and anything else blocking your access. On the back of the container at the backside is the blasting water line, and at the top is the boiling drool borderline. These lines are generally coloured blue and red respectively, but some are just white.
3. Cut the lower tube at the attachment point to the tank, leaving at least 1 inch of tubing protruding. Install a three-way valve from the kit in the lower pipe, with the handle easily accessible. Slide the nut over the tubing, rock the tubing onto the flared fitting on both ends, and tighten the nuts on the fitting. The center port of the valve should be facing toward the installation point of the second valve.
Bleed the saturate heater. Place the douse heater on the absent of the RV and lower the access panel. Near the top of the container is a impulse relief valve with a lever on it. Carefully shift the lever upward to Proceeds any air compel in the container. This ensures the valves properly bypass the water supply to the tank and are easy to operate.
5. Install a piece of PEX tubing supplied in the kit between the two center ports of the the three-way valves. Cut the tubing to length and assemble in the same manner as the valves. The ports should be facing each other, top to bottom, so the tubing is vertically oriented after installation. Other configurations my be necessary due to space issues or non-standard factory tubing connections. The bypass kit is now completed.
