Vinyl hardtops get a vinyl chapter placed over the metal top of a motorcar. They dish out the appearance of a convertible, nevertheless the top is solid and steady approximative a accepted hardtop. A vinyl hardtop was one of the options on early Mustangs. Replacing the vinyl hardtop on your Mustang is a quite straightforward system that requires basic tools you doable already carry. You should be able to convert the vinyl hardtop on your Mustang in less than a date.
Instructions
1. Remove all trim covering the vinyl on all sides of the top of the van. You may commitment a screwdriver for this, or simply application a putty frog sticker To hull the trim elsewhere from the vinyl. Whether the trim pieces are rusted, moderate them with advanced trim pieces purchased from a Mustang parts store.
2. Heat the surface of the vinyl with a heat gun. Authorize the paint to dry for two hours.3. Locate the seams in the new vinyl top. Advantage a putty poniard and your hands To hull the infant vinyl top outside from the top of the Mustang. Whether there is any rust on the top of the motorcar, application a sanding rotate to sand it down. Colouring the top of the roof with rust-inhibiting colouring.
Align the seams with the small punch marks on the glass channels around the Mustang's windows. These are the guide for the seams that will help you with the installation.
4. Apply spray adhesive to the top of the car. Place the vinyl top over the car, and line the seams up in the correct locations. Smooth the top out from the center of the roof toward the sides. Add more adhesive as necessary to accomplish a strong bond.
5. Trim any excess vinyl that hangs over the windows with a razor blade. You can leave a little excess vinyl for flexibility. The trim will hide a small amount of excess vinyl. Cut small slits along the edges of the vinyl to help them fold tightly over curved spaces. The slits will be hidden by the trim pieces.
6. Use a putty knife to push the vinyl into the drip rails of the Mustang. Press the vinyl behind the windshield molding clips. Reposition the trim pieces around the vinyl top. Reattach the original screws, or new screws if the original ones were rusty.
