Whether you've had to knock on the starter with a hammer on your Dodge Dakota to receive it to turn the engine over, then it's been telling you to change it. In some cases, the starter Testament hit a Apartment lodgings spot and extreme there no argument what you crack to conclude. Replacing it can be done at a repair shop provided you necessity to spend the cash on parts and labour, or you can create it in your own yard. The starter Testament dictate when it needs to be replaced, nevertheless you compulsion to figure away where you thirst for to transform it whereas sooner or successive, the starter is going to die. Whether you hold a tow supply, you can annex the Dakota sent local or to the repair shop. Provided you requirement to save some downbeat process on labour charges and get some tools Homewards, why not deliberate tackling the project yourself?
Instructions
Replace the Starter on a Dodge Dakota
1. It is recommended to manage it up on motorcar ramps, however lifting the Motor lorry with a floor jack and placing jack stands on the front left and honest frame rails would labour too.3. Operate the parking brake and city a rotate chock behind one of the rear tires.4.
Lay on safety glasses.2. Uplift the front of the Dodge Dakota.
Open the hood and remove the negative terminal from the battery. A hand wrench or ratchet and socket will work.
5. Crawl under the Dakota (on a creeper if you have one) with all your tools and locate the starter on the low end of the engine where it meets the transmission flywheel.
6. Remove the bottom bolt and washer that secure the starter to the transmission housing. On manual transmission models, there will be a stud on the transmission housing with a nut securing the starter that will have to be removed first.
7. Support the starter in one hand and remove the second bolt supporting the starter to the transmission housing. You may have to slide the transmission cooler tube bracket forward on automatic models to make room to extract the starter.
8. Lower the starter enough in your hand to expose the wires attached to it. Remove the nut holding the positive battery cable. Remove the battery cable solenoid terminal wire. Remove the B+ cable from the starter. Remove the starter when the wires are disconnected.
9. Attach the wires in the same manner to the new starter that you removed them from the old one. It may be tricky trying to support the starter and affix and tighten the wires.
10. Position the starter to the transmission housing and insert it into the starter cavity. Hold the starter in place and thread in the washer and bolts. Tighten securely.
11. Remove all the tools and equipment from under the Dakota.
12. Reattach the negative battery terminal to the battery. Test start the Dakota.
