You read that the engine in your Ford Explorer won't birth. According to the battery assessment, there are no problems there. You dispassionate replaced the alternator remain year. And so, chances are your starter is the disagreement. While you could admit a mechanic alternate the starter for you, that can be rather expensive. Instead, ensue the steps below to exchange the starter in your 2000-2004 Ford Explorer yourself.
Instructions
Remove the Malfunctioning Starter
1. Grounds your Ford Explorer on a comparable surface, activate the emergency brake and deposit blocks latest the back tires for safety. Disconnect the con battery cable with a terminal puller. Stand the front aim of the vehivle with a jack for easier access to the starter.
2. Grasp the plastic shell of the hard-shell connector at the S-terminal and pull straight off, without pulling the wire. Whether damage occurs, transform those items very.
3. Detach all wires connected to the starter, including the ground wire on the starter Engine bolt stud, starter cable and the solenoid push-on connector. Some Ford Explorer starter motors hog a self-threading bolt holding the starter cable in habitat.
Lower the vehicle to the ground and reconnect the negative battery cable. Disconnecting the battery cable may cause the Powertrain Control Module (PCM) to lose information. After testing to make sure the vehicle starts, drive at least ten miles for the PCM to relearn its adaptive strategies.
Hire your malfunctioning starter to the parts store with you. Aftermarket distributors remanufacture most of the starters they sell, so you can imaginable annex a fragmentary credit toward your brand-new starter by exchanging your ancient one. Be confident that you yield disquiet not to damage the starter in transit, for the greater action it is in, the extra you can shop for for it.
6. Invest in a replacement starter that has the alike or higher cranking ability (authority rating) as the original starter in your Ford Explorer. Also, match the bolt patterns, drive gears and electrical connections. Your owner's manual may list specifications or the auto parts technician will help you determine them. Download a free owner's manual at Ford Fleet.
Install the New Starter
7. Position the new starter in the correct location and install with the mounting bolts. Torque the mounting bolts between 15 to19 foot pounds (21 to 27 Nm).
8. Push the solenoid connector straight on to the starter and listen for a click to be certain of proper installation.
9. Attach starter cable nut to the B-terminal of the solenoid. Tighten the nut between 80 to 123 inch pounds (9 to 14 Nm). Reconnect the additional starter wiring and replace the red safety cap.
10.4. Remove the starter mounting bolts, starting with the upper bolt, and country them in the jar for protected interest until following. Then remove the malfunctioning starter from the engine.5.
