The water pump delivers cooling moisten up to the Engine.
3. Remove the bolts for the water pump housing and slide off the housing. Remove the water pump from the base, sliding its impeller around the motor shaft and then removing the gasket and steel plate.4.
Instructions
1. Unscrew and remove the bolts connecting the Engine's lower quota to the midsection. Disconnect the shift linkage and seperate the lower housing from the upper.
2. Remove and save the gasket whether one was located in between the housings. Share indication of the speck of each of the locator pins for connecting the two housings.
The flood pump in an outboard Engine can buy clogged and damaged from debris in the douse getting pulled up into it. Whether you don't Disinfected the pump absent, you Testament eventually want to alter it. Replacing a pump in an outboard boat Engine is also complicated than replacing a automobile's pump; the outboard pump is mythical up of seperate components that are removed and installed separately. You should moderate all of these components well-adjusted, replacing the abundant pump.
Install the replacement pump in the base, starting with the steel plate, a new gasket and then the impeller. Line up and slide the pump tubes together.
5. Reinstall the housing to the water pump with its bolts.
6. Apply an anti-seize compound to the threads of the bolts for the lower unit's housing.
7. Reconnect the lower housing to the midsection using the locater pins as a guide and apply the bolts; do not over-tighten them with your wrench.
