Automotive headliners are make-believe from material or vinyl info that covers the ceiling inside a vehivle. This counsel is glued to a Numb board shaped to fit on the ceiling. Over eternity, the glue weakens and the counsel may sag, hang down or flap enclosing. This not solitary looks poor, on the contrary it can block the Chauffeur's theory outside of side windows and the rearview mirror, creating a safety hazard. You can arrange your own headliner instead of paying distinct hundred dollars To possess it repaired.
Instructions
1. Remove the experienced headliner from the van. You may charge to slide a Apartment lodgings tendency screwdriver along the column to help them pop off.3. Pull on the headliner and board, starting in a corner.
2. Pop the plastic pillars off once the screws acquire been removed. Foundation at the backside and chore your conduct up. Set off by using a Phillips screwdriver to remove the screws from the plastic pillars located in Everyone corner of the automobile, from the sprint to the ceiling. Whether the vehicle has rear doors, there Testament be more pillars extreme the front doors. There is extremely plastic trim above the doors holding the headliner in situate. Remove this with a screwdriver.
The entire thing should come down by carefully prying it loose. Don't break the board--it can be expensive to replace.
4. Place the headliner and board on a flat table or clean area on the ground. Pull the headliner material completely off of the board.
5. Measure the board and the new material, leaving 2 inches of overhang on all sides. Cut the new material, using the board as a template.
6. Turn the new material face-down on a clean surface. Lightly spray adhesive over the entire piece, spraying extra along the edges and center. Spray the same amount on the board. Allow both pieces to sit for about five minutes, or until the glue is slightly tacky.
7. Lay the material on top of the board, sticky sides facing each other. Center the material and use your hands or a plastic squeegee to smooth it out, starting at the center and working toward the edges.
8. Install the board in the car using the reverse of the steps in the removal process. Tuck the extra material along the edges up and around the back of the board. Cover it with the trim in the car.
