The Ford cruise state switch is secured to the steering limit with a facile retaining pin or clip (depending on the year of your Ford). This is normal. The paperclip needs to push against the release tab on the inside of the switch. Push against the release tab while you pull the cruise control switch off the steering column.4.
1. Verify, or turn, the cruise control switch to the "off" position.
2. Straighten out a paperclip and insert it into the small hole on the end of the cruise control switch.
3. Push the paperclip in as far as it will go. You should feel resistance. The cruise control module monitors the Ford vehicle's quickness and allows the Chauffeur to allot the quickness so that the vehicle maintains that allot quickness without any very input from the Chauffeur. Unfortunately, some Ford cruise bridle modules compass been admitted to overheat and fail. When this happens, you exigency to interchange the cruise control switch.
Instructions
Install the new cruise control switch by sliding it onto the steering column. Use the same orientation as the old switch during installation.
