The Dodge Camper holds extended mortals and augmented lading than a motorcar and provides a comfortable handle.8. Align the new shocks properly and mount the upper and lower bolts. Torque them to 65 ft-lb.9.
Instructions
Replace the Front Struts in a Caravan
1. Up thrust your Camper with a jack, and column the frame with jack stands. Remove the front wheels with a tire iron, and fix the strut assemblies. They contemplation prize two tubes that slide in and elsewhere of Everyone other and connect to the steering knuckle and the frame of the minivan.
2. Remove the bolts holding down the brake hose and rapidity sensor bracket to the side of the strut with a ratchet. The brake hose is a Supple department that runs from the rotate hub ended the strut.
3. Disconnect the stabilizer bar link from the strut meeting by removing the follower approximately halfway between the top and backside of the meeting. End the ratchet to pull off the steering knuckle bracket bolts on the backside of the meeting and the upper strut mounting nuts. Pull away the strut assembly and location which side of the machine it came from with a permanent marker.
4. Repeat Steps 2 and 3 on the other side of the front of the motorcar.
5. Compare the elderly struts to the dissimilar ones to figure away which strut goes on which side. Mount the new strut assembly, and attach the upper mounting nuts. Adjust your torque wrench to 21 ft-lb, and tighten the nuts until you feel the wrench slip. Reattach the steering knuckle bracket in the same position as the original, and torque the bolts to 60 ft-lb. Then turn the bolts an additional quarter turn.
6. Attach the stabilizer bar link nut, and torque it to 65 ft-lb. Align the bracket for the wheel speed sensor and the brake hose to the strut assembly and insert the bolts. Torque them to 10 ft-lb. Mount the front wheels again, and lower the Caravan from the jack stands.
Replace the Rear Shocks in a Caravan
7. Lift the rear end of your Caravan, and support the frame with jack stands. Support the rear axle with a jack stand as well. Locate the shock absorber, which looks like a slender tube that slides in and out of a slightly larger tube. Unbolt the upper and lower mounting bolts, and remove the shocks from the rear suspension.
Accumulate it that design by replacing your shocks and struts after 60,000 miles under typical driving conditions. With the Correct tools you can achieve it, and it' yet less expensive than paying a mechanic to complete it for you. This course works capital for design agedness 2000 to 2005.
Remove the jack stands, and lower the rear end of the Caravan.
