Pocket money Brakes on a 1999 Dodge Car
The braking development on your 1999 Dodge car includes the brake pads, brake rotors and the brake caliper. The brake caliper is the leading Element that pushes the back of the outer brake pad against the back facing of the brake rotor. As the outer brake pad compresses onto the brake rotor, the inner brake pad pulls to the front facing of the brake rotor. Slide the wheel back onto the hub and screw all of the lug nuts onto the lugs. Tighten the lug nuts until the wheel turns. Move to the other wheels and follow the same directions, as above, for replacing the brakes.
Stadium your 1999 Dodge vehivle on a commensurate surface. Then push the parking brake in.
2. Loosen all of the lug nuts from the front Chauffeur's side rotate very as the front passenger's side shove with a tire object or lug wrench. Turn the lug nuts counterclockwise to loosen them.
3. Jack the front objective of your 1999 Dodge car up. Place a jack stand under the side frame on both sides of the motorcar. Be definite to position the stands near the front wheels so that the weight of the front edge sits evenly on the stands.
4. Lower the jack to the top of the safety stands. Gaze the motorcar to arrange persuaded it is safely and securely on top of the stands. Ok the jack in apartment.
5. Unscrew all of the lug nuts from both front wheels and pull them off. Locate the wheels in a Apartment lodgings position to prevent rolling.
6. Modification to the front Chauffeur's side spin and place the two slide bolts in the back of the brake caliper. One of the slide bolts is at the top of the caliper, and the other slide bolt is at the backside of the caliper. Loosen and remove the slide bolts with a 3/8-inch guide ratchet and socket.
7. Encompass a slender pry bar into the access gap on the side of the brake caliper. Pry the outer brake pad back and forth In relation to the back of the brake caliper until the caliper becomes loose.
8. Pull the brake caliper from the side of the brake rotor. Provided the caliper is much tight, manipulate the bitty pry bar to pry the backside of the caliper off. Then, pull the caliper off of the rotor. Hang the caliper on one of the steering components last the turn hub meeting with a abundance of rope. The front strut and the front spring are crack places to hang the brake caliper.
9. Pry the inside brake pad away of the metal retaining clip on the inner item of the brake caliper with the insufficient pry bar.
10. Position a C-clamp into the caliper so that the adjusting rod is facing the out brake pad. Then compress the gone brake pad In relation to the caliper cylinder. Hang in to compress the gone brake pad against the caliper cylinder until the cylinder is flush with the absent of the brake caliper. Loosen the C-clamp and remove it from the caliper.
11. Pry the outside brake pad out of the metal retaining clip with the small pry bar. Then install the new replacement brake pads into the retaining clips. Remove the rope and hang the caliper back onto the side of the rotor. Push both slide bolts into the rear of the caliper and screw the slide bolts in until tight. Then tighten the slide bolts with the ratchet and socket.
12. The friction from the brake pads sliding against the turning brake rotor is what stops the vehivle. Examine the brakes for replacement between 30,000 and 40,000 miles.
Instructions
1. When finished replacing the brakes on each wheel hub, jack the van back up and slide the stands out. Slowly lower the van to the ground. Then pull the jack out from under the van.13. Crank the engine of your 1999 Dodge van and give the brake pedal a few pushes in and out to properly seat the brake pads near the facing of the brake rotors. Turn the engine off and close the hood.
