Brake calipers press the brake pads into the rotors to close the motorcar.
The Mercury Grand Marquis is a luxury vehicle with a comfortable guide. According to Edmunds.com, the Grand Marquis "exhibits old-school automotive architecture with its stout on the other hand enormous body-on-frame interpretation, solid rear axle and softly tuned suspension calibrations." It is a enormous vehicle, which resources that there is extended wear on the brakes than there might otherwise be on other cars. When you actualize hearing squealing while the brakes are busy, it may be date to exchange the brake pads. Replacing the brake pads offers you the fighting chance to inspect the rotors and convert them further, whether decisive.
Examine the discs or rotors for cracks, gouges and unevenness between different areas. If there is damage or wear, pull the retention ring off and remove the rotor. Put a new rotor on and place a new retention ring on the rotor to hold it on.5.
Avail a tire iron to loosen the lug nuts on the wheels. Lift the speck of the van with a floor jack and allot the frame on jack stands. Remove the lug nuts and pull the wheels off.
2. Allot and remove the brake calipers. The calipers are U-shaped parts that receive the rotors on the exteriors of the shove hubs. Hang a wire hanger from the frame of the motorcar. Unbolt the calipers with a wrench and hang them from the wire hanger. Determine not let the calipers dangle from the brake column, or the brake line may be damaged.
3. Remove the pads, anchor plates, the guide pins and the guide pin boots from the calipers. Examine the guide pins and boots for wear and replace them if they are worn. Reassemble the caliper assemblies with new anchor plates, bolts and new brake pads. Torque the bolts to 118 ft-lbs.
4.
Instructions
1. Lift the purpose of your Grand Marquis with the brakes that devoir repair and remove the wheels. Whether both the front and rear ends of the vehivle devoir replacement brakes, choose one extremity to begin and unabridged all the steps there before tackling the other borderline.Bolt the calipers back onto the wheel hubs and mount the wheels. Torque the lug nuts to 100 ft-lbs. Lower the car. Repeat steps 1 to 5 on the other side of the car, and on the other end if both front and rear brakes needed replacing.
