Saturn SL1 sedan
The Saturn SL1 sedan was manufactured with a 12-volt alternating generator coupled with a dissension ground battery. This charging transaction powers the automobile's ignition method and the secondary accessories. The alternator is prone to wear, and after senility of bag must be replaced. The standard backyard mechanic can transform an alternator in the SL1 in approximately an period.
Instructions
Replacing a Saturn SL1 alternator
1. Disconnect the battery by turning the certain terminal bolt counterclockwise. Settle the terminal wire aside. Arrange not remit it to touch the battery.
2. Jack the Saturn up at the passenger side turn and remove the rotate by turning the lug nuts counterclockwise. Allot the turn and tire aside.
3. Remove the plastic inner fender shield by turning the screw counterclockwise, then pulling the plastic unrestrained from the pop rivets. Allot the shield aside.
4. Disconnect the alternator's important charge wire by reaching washed-up the spin bright-eyed and turning the output publish stone counterclockwise.
5. Press the tension pulley firmly to Proceeds the tension on the influential ride region, then slide the cummerbund off of the alternator's pulley revolve. The region can be left hanging, as stretched as it does not lose its road over the other pulleys on the engine.
6. Unbolt the alternator from the mount by reaching into the engine compartment concluded the wheel well and turning the two mount bolts counterclockwise. Manipulate the alternator out of the engine compartment through the wheel well.
7. Reconnect the primary charge post nut, securing the output wire back onto the alternator.
8.10. Replace the fender skirt shield by pressing it back onto its clips or pop rivets, then turning its screws clockwise.11.
Position a new alternator into the mount and secure it by turning its bolts clockwise. The alternator should be mounted firmly and not wiggle.9. Replace the drive belt by pressing the tension pulley and sliding the belt back onto the alternator's pulley wheel.
Replace the wheel, tighten the lug nuts and lower the car from the jack.
12. Reconnect the battery's positive terminal by turning the bolt clockwise onto the battery.
