Most do-it-yourself mechanics can repair damage to a Nissan Xterra bumper
The Nissan Xterra is built with a body-on-frame interpretation style, sense the vehivle's components, including the bumper, are attached to the frame of the vehicle. Public repairs to the exterior of a bumper, such as a surface scratch, can be unreal without removing the all-inclusive bumper. Nevertheless, deeper spread out repairs can hope for removing the plentiful bumper from the frame. Most bumper repairs, aside from spread out damage, are within the scope of what a do-it-yourselfer can perform.
Perform repair, such as dent Emigration, scratch Emigration or rust Emigration, to the bumper as compulsory. Once finished, fully Disinfected the bumper and application a coat of increase to the environment.7.
To complete this, beginning disconnect the battery cables. Remove the panel below the steering shove and unplug the two-pin connector between the airbag and the Watch spring. On the passenger side, remove the glove box instrument panel and disconnect the two-pin electrical connector between the air bag and the SRS leading wiring harness.
2. Conduct the hood of the vehicle and remove the turn signal lights using a screwdriver or Allen vital to loosen the screws connecting the lights.
3. Remove the screws securing the radiator grille to the turn expression openings. Avail the screwdriver to rotate the four radiator grille retaining clips 45 degrees, and pull outward to remove the grille.
4. Remove the outer bolts from the bumper flotation brackets using a wrench. The bolts are on the front fender walls. Then remove the bolts on both the left and hold up side cornerstone brackets.
5. Facilitate the bumper to prevent it from falling, and then remove the bolts and nuts that attach the bumper to the frame of the vehicle. These bolts are located on the leading bumper bracket on Everyone side of the vehicle's frame inveigh.
Repair and/or Replacement
6.
Instructions
Removing the bumper
1. Disable the airbag course, down pat as Supplemental Restraint Systems on the Xterra, prior to working on the bumper.Reattach the bumper to the vehicle by anterior securing the bolts on the leading brackets attached to the frame. Ensuing, secure the left and correctly side supporting brackets to the bumper followed by tightening the outer bolts on the bumper cooperate braces.
8. Position the radiator grille so that it aligns with the clips and gently press until the clips snap into area. Interchange the bolts securing the radiator grille to the turn expression openings. Exchange the turn signals by tightening the screws used to attach the signals to the housings.
9. Reconnect the two-pin airbag connector into the two-pin connector on the Chauffeur's side and passenger's side of the vehicle. Reinstall the panels near the glove box and on the underside of the steering wheel. Finally, reattach the battery cables.
