Remove the Chauffeur Side Mirror From a Nissan Murano
Removing a side view mirror on a Nissan Murano does not desire employing an expensive oppose or repair shop to act it. Replacement mirrors from the Nissan dealer Testament value hundreds of dollars. There are many kind aftermarket mirror dealers that Testament save you a cogent size of mode by purchasing the mirrors from them. With a inappreciable mechanical savvy, you can install it yourself and save much another bankroll.
Instructions
1. Accessible the Chauffeur's side door and capacity down the window. Turn the ignition guide to the off position; remove the keys to prevent unexpected efficacy call for during the procedure.
2. Fix the inconsiderable trap door (square) in the door holder trim. Pry the door off the trim with a dwarf slotted screwdriver.
3. Remove the screw under the trap door with a Phillips attitude screwdriver.
4. Exercise the microscopic slotted screwdriver to pry the window control module from the front of the arm rest meeting.
5. Pull the two wire harness plugs outside from underneath the window direction module. Allot the administration module in a protected domicile.
6. Remove the two bracket retaining screws revealed by removing the window domination module.
7. Pry the door knob meeting elsewhere from the door panel using a plastic pry item. Day one at the top and attempt your means down Everyone side and then the backside until its disengaged from the door. Disconnect the wire harness under the door handle assembly and then remove the assembly. Set it aside so it does not get damaged.
8. Remove the screw above the vertically angled door pull with a Phillips head screwdriver.
9. Pull out the door panel to disengage the retaining clips of the panel from their seats under the panel. Unplug the door light wire harness and then remove the door panel. Place it in a safe place where it will not get damaged.12.
Start on the outside edge then work along the bottom and up to the front side.10. Support the door panel a few inches away from the frame and then disconnect the door handle rods from the panel.11.
Gently pry off the side view mirror sail from the interior door frame. This is the remaining triangular shaped molding remaining on the door frame opposite the side view mirror.
13. Unplug the side view mirror wire harness.
14. Remove the three retaining nuts securing the side view mirror studs with a ratchet, small extension and 10-mm socket. Support the mirror with one hand before removing the last nut. Remove the mirror by gently prying away from the exterior door frame and feeding the wire harness through the access hole.
