Install a windscreen on your K5 Blazer.
Push a nylon cord into this groove, starting at the bottom center of the gasket and leaving about a foot of cord hanging out. End at the starting point, leaving another foot of cord dangling out.5. Put on your work gloves and position the windshield into the windshield frame from outside of the K5. The Chevy K5 Blazer was introduced in 1969 as the smallest full-size SUV of the GM C/K trucks. These directions effect after you keep removed the gray-haired windscreen.
Instructions
1. Hot up the advanced gasket by attention it in a broiling country until it is soft and pliable.
2. Stretch the gasket encircling the new windshield, making sure the slit on the gasket faces outside the Blazer. Run a thin bead of sealant along the outermost channel on the gasket.
3. Spread petroleum jelly into this outer groove, putting a little extra at the top and bottom center.
4.You can install a windscreen on a K5 Blazer due from at rest using a rare supplies that you can acquire from any Car parts store. You Testament extremity to enlist the advice of an assistant to gross this business. It Testament by oneself capture you approximately an generation to integrated this effort.
At the same time, have your assistant guide it into place from inside the vehicle. Have the assistant place the cord ends inside the vehicle first.
6. Press the gasket onto the frame with your hands while your assistant pulls one of the cords slowly around the whole perimeter of the windshield. This will pull the lip of the gasket into the vehicle.
7. Allow the sealant to dry for 48 hours before moving the vehicle.
