A leak from a automobile window seal can determinant a chock-full dilemma still whether it is a inconsequential one. It is substantial to arrest the leak in the early stages, nevertheless much then it can effect a wet dashboard, seat or floor. Examine the channel for cracks, rust or missing caulk. Check if there are cracks in the window itself.3. Determine the next course of action.
1. Find the source of the leak. If you suspect it is a small leak, spray a garden hose along the window seam and see where the water seeps through. You may need the assistance of another person to spray the window while you sit inside the vehicle and look for the leak.
2. Remove the rubber that goes along the edge of the window by carefully prying up from the window channel with your fingers. A mildew-like or musty Aroma can be a choice indicator that your machine has a leak somewhere. Once you finger the hot water, you can bring about repairs on the window seal.
Instructions
If you found wet or missing caulk in the channel, or a crack in the channel, you can recaulk the window channel. If there is rust, you will need to repair and repaint, and it could get complicated. This will most likely need to be repaired by a professional as will a crack in the glass itself.
4. Recaulk the window after completely removing the rubber lining. Add a small amount of lighter fluid or paint thinner to a soft cloth and clean out the window channel as best you can. Slide a polyurethane sealant into a caulking gun. Add the caulk into the channel around the perimeter of the window. Replace the rubber trim before the caulk cures. Push it down with a 2-by-4-inch piece of wood. Secure the trim in place with strips of duct tape. Avoid getting your car wet for the next day or two or until the caulk has completely dried.
