The 1999 Chevrolet 1500 pickup uses a Look-alike, vertical-channel, cable-drive regulator. Remove the window-securing bolt from each channel where the window is attached on the bottom to the regulator, using a 10 mm socket.4. Wedge the window into the Up position, using the flat head screwdriver. Push the screwdriver down between the window and the door to keep it from falling. Another corporeality that should be checked is provided the Engine can be heard running when the switch is activated. Provided so, the Engine is not the dispute.
Instructions
1. Remove the two Phillips intellect screws located in the armrest. Subsume a flat head screwdriver between the door panel and door. Pry the trim fasteners outside on all three corners of the door panel.
2. Lift the door panel up enough to dislodge the top of the door panel then pull it away from the door far enough to disconnect the electrical harness from the window switch. Peel the moisture shield back to expose the window regulator.
3. Unplug the electrical connector from the window motor. The window Engine and regulator are replaced as a unit. The majority of the extent, the enigma is with the regulator. The cable breaks easily provided there is any resistence to the window movement. One suggestion is to analysis the effectiveness window fuse and the relay aboriginal to build certain that it is not a influence holy mess.
5. Remove the nuts securing the window regulator to the door, using a socket. Remove the window regulator and window motor as a unit from the door. Install the new window motor and regulator in the reverse order of removal.
