Most late-model Toyota Tacoma trucks compass a mill alarm installed however older models are ready for just out alarms. Installing a van alarm in the Toyota Tacoma requires a working consciousness of machine electrical systems and the licence wiring diagram. Installing the alarm on a Toyota Tacoma takes a tiny patience and approximately two hours.
Instructions
1. Glance at the alarm installation textbook carefully and distinguish all of the components and connections. Airy the hood and remove the good battery cable from the terminal.
2. Catch a highly visible mark for the LED flash and drill a gap. Snap the LED in lay and drop the wire under the Tacoma's sprint. Establish the energy lock relay, whether the Toyota Motor lorry is so equipped and connect the alarm lock module.
3. Install the shock sensor per the manufacturer's recommendation. Mount the alarm siren in an open area, facing the engine to limit water contact when driving. Feed the power and siren wires through the firewall using an existing hole or by drilling a new one.5.
Identify the starter wire in the ignition harness and attach the start disable relay.4. Connect the alarm power wire to the positive battery cable and run it along the firewall to the driver's side.
Attach all of the wires to the alarm control module and secure the module as far into the dash as possible. Connect the positive battery cable and test the alarm. Adjust the sensitivity if desired and secure loose wires with zip ties.
