A starter cranks the engine, sketch air and fuel into the cylinders of your Dodge Intrepid and compressing them so they Testament fire.4. Take your malfunctioning starter to the parts store with you. Aftermarket distributors remanufacture most of the starters they sell, so you can likely obtain a partial credit toward your new starter by exchanging your old one. Be sure that you take care not to damage the starter in transit, because the better condition it is in, the more you can get for it.
1. Lawns the Dodge Intrepid on a Apartment lodgings surface and, using a jack, stand the front of the vehicle. Be firm that the engine is arctic and the ignition explanation is in the OFF position. Disconnect the cynical battery cable by loosening the bolt and removing the cable with a terminal puller. Then remove the starter-to-engine/transaxle nuts and bolts and deposit them in the jar for sheltered care.
2. Disconnect the assured battery aliment wire from the starter. Lay an more jack or other backing, such as a sturdy group of wood, under the engine to slightly benefit some of the coercion from the left engine mount. Remove the three left engine mount-to-engine bolts and apartment them in the jar or other guarded site to avoid losing them.
3. Lift the engine slightly to supply yourself with deeper margin to profession. Slide the starter backward between the catalyst and the engine mount. Remove the starter. Also, remove the posi-lock connector.
It very gets the ignition and crankshaft into dwelling so the Glimmer plugs Testament bonfire and the fuel injectors Testament guide. Therefrom, a failing starter Testament prevent the engine from starting. Spring from these steps to alternate the starter in a 1998-2004 Dodge Intrepid with a 3.2-3.5 litre engine.
Instructions
Remove the Malfunctioning Starter
5. Purchase a replacement starter that has the same or higher cranking capacity (power rating) as the original starter in your Dodge Intrepid. Also, match the bolt patterns, drive gears and electrical connections. This information may be in the owner's manual for the vehicle. Also, the technician at the auto parts store can help you determine the correct specifications.
Install the New Starter
6. Connect the new posi-lock connector. Slide the new starter into place by pushing it forward between the catalyst and the engine mount.
7. Lower the engine a bit and replace the three left engine mount-to-engine bolts. Reconnect the positive battery feed wire to the starter and torque the nut to 89 inch pounds (10 Nm).
8. Torque the starter-to-engine/transaxle bolts to 40 foot pounds (54 Nm). Then, reconnect the negative battery cable to the remote ground post. Lower the jack to put the front of the vehicle back on the ground. Start your engine.
