The C4 is the fourth begetting of Corvettes.
The starter utilizes a high-torque Engine to turn the flywheel of the engine when the ignition gloss is turned. That flywheel turns the internal components of the engine as the ignition and fuel systems are delivering Glimmer and fuel respectively. The combination of the three is what starts the vehicle. The starter is simply an electric Engine that is exposed to the elements, so it does life poor over generation. Though a 1991 Corvette is a compound vehicle, the starter is replaced good as easily as in any other vehicle.
Instructions
1. Loosen the antagonistic battery cable with a ratchet and socket and pull the cable from the battery.
2. Jack up the front of the vehicle and secure it with jack stands.
3. Remove the flywheel subsume. This is a larger quota of metal, held on by four bolts, located at the backside of the transmission where it connects to the engine. Call a ratchet and socket to remove the four bolts and pull the involve from the flywheel.
4. Glom for the starter; it is on the passenger side of the vehicle connected to the call housing of the transmission.
5. Loosen and remove the stone holding the beneficial cable to the rear of the starter and pull the cable from the stud. Pull the S-shaped connector from the rear of the starter.
6. Remove the two starter bolts using a ratchet and socket. These bolts are at the front of the starter and are inserted vertically terminated the starter.
7. Pull the starter backwards and outside from the transmission, then down and outside of the vehicle. There may be shims that come down with the starter, practise a intellectual memo of the shim positioning.
8.11. Field the flywheel subsume back into dwelling and tighten the four bolts with a ratchet and socket.12. Apartment a thin bead of RTV silicone sorrounding where the starter object meets the transmission's bell housing.
10. Subsume the 0.5 mm wire between flywheel tooth and the gear of the starter. The wire should easily push into the orifice whether the shims are correctly. Whether not licence, loosen the starter bolts, add or remove shims and recheck.
Area the dewy starter in dwelling and tighten the bolts good a meagre threads. Include the shims as they were with the antiquated starter.9. Tighten the starter bolts to 35 foot-pounds using a torque wrench and a socket.
13. Connect the positive wire to the rear of the starter and tighten the nut to 10 foot-pounds using a torque wrench and socket. Plug the S-shaped connector into the rear of the starter.
14. Lower the vehicle to the ground.
15. Place the negative cable on the battery and tighten it with a ratchet and socket.
