Modify a 1994 Mustang Serpentine Belt
The tension pulley is located between the air conditioner compressor pulley and the crankshaft pulley.2. Rotate the tension pulley upward with the breaker bar to create slack in the serpentine belt. You can modify the zone without the overhaul of a mechanic.
Instructions
1. Comprehend the bound of the breaker bar into the square gap in the Centre of the tension pulley.The serpentine cummerbund in the 1994 Ford Mustang is used to competence many of the finery systems in your vehicle, such as the influence steering and the crankshaft. Older mannequin cars had a series of V-belts, which took up engine compartment margin and were hard to interchange. The serpentine belt replaces multiple V-belts. Whether you hear a blaring squeaking in your engine it is feasible a worn serpentine zone.
3. Pull the belt off of one of the pulleys and slowly lower the breaker bar. Do not allow the tensioner pulley to spring back to its original location as you will damage the pulley.
4. Remove the belt from the remaining pulleys and discard it. The 1994 Ford Mustang serpentine belt wraps around seven pulleys.
5. Place the replacement serpentine belt on all of the pulleys except the tensioner pulley. Use the belt diagram located in the engine compartment as a guide to properly route the belt. If the diagram is missing, follow a link to the diagram in the Resources section. Ensure the belt is seated in the groove of the pulleys. The belt will not correctly drive the accessory parts if it is not correctly positioned.
6. Raise the tension pulley with the breaker bar and slip the belt over the tension pulley.
7. Return the tensioner pulley to its original location to tighten the belt around all of the pulleys.
