Remove the Ignition Switch in a Honda Acquiesce 93
In 1993, Honda firm to equip its Acquiesce with a passenger-side air bag. This makes it bottom line to disable both the driver- and passenger-side air bags during replacement of the ignition switch. Failing to determine so could deploy the air bags whether you accidentally hit an influence sensor near the steering trundle. Nevertheless, this business is not as dynamite as you may deem. With the Correct procedure, you can safely transform Homewards the ignition switch in your 1993 Correspond replica.
Instructions
1. Unfasten the torx bolts under the mini covers using a ratchet and a T30 torx bit and remove the bag meeting from the steering revolve. Put the bag in a sheltered apartment away from your working area with the cover facing up.9.
Unfasten the two torx bolts securing the lower lid on the steering spin using a ratchet and torx bit. Pull off the coral shorting connector from the underside of the lid and place the lid aside.
4. Extent washed-up the steering embrace opening, unplug the air-bag electrical connector and include the blood shorting connector to the air bag side of the unplugged connector.
5. Unfasten the three glove-box mounting screws and assign the glove box aside using a Phillips screwdriver.
6. Unplug the passenger air-bag electrical connector and contain the chestnut shorting connector located coming to the connector into the air-bag side of the unplugged connector.
7. Pry off the inconsequential contain at the end and on Everyone side of the steering trundle using a diminutive flat-head screwdriver.
8. Fix the front wheels to location forward and remove the material from the ignition.2. Disconnect the brunet battery cable and then the blooming battery cable, thanks to grouping, using a wrench.3.
Unplug the horn connector located on the upper side of the steering wheel assembly and the cruise control switch located off center and towards the right of the steering wheel assembly.
10. Make alignment marks on the steering column shaft, at the center of the steering wheel, and the steering wheel assembly so that you can reinstall the steering wheel in the same exact position. Use a marker.
11. Unfasten the steering-wheel retaining nut on the center of the assembly using a ratchet, ratchet extension and socket. Hold the steering wheel steady with one hand as you remove the retaining nut.
12. Rock the steering wheel carefully from side to side as you pull the wheel off the center shaft. If the steering wheel is stuck, install a steering wheel puller on the assembly and detach the wheel from the shaft.
13. Remove the upper and lower steering column covers using a Phillips screwdriver.
14. Unplug the ignition switch connector.
15. Insert the key into the lock cylinder and turn the key to the "On" position.
16. Unfasten the two ignition-switch mounting bolts from the steering column using a ratchet, ratchet extension and socket. Then remove the switch from the steering column.
